Pinion Washer
Pinion Washer
For Dana transfer case and differential
Pinion washer for Dana 18 transfer case and Dana axles. This component is used beneath the pinion nut on the propshaft connection at the front and rear axles, as well as on the input and output shafts of the Dana 18 transfer case. An essential small component for proper assembly and sealing.
|
Material Steel |
Application Transfer case / Front/rear axle |
|
Position Under pinion nut |
Quantity 1 piece (multiple required per vehicle) |
Features
- Suitable for Dana 18 transfer case
- Suitable for Dana front axles (Dana 25/27)
- Suitable for Dana rear axles (Dana 41/44)
- Fits between yoke and pinion nut
- Critical component for proper assembly
★ Replacement part for the original pinion washer. During restoration or overhaul, always check the condition of these washers and replace if necessary.
Installation notes
The pinion washer fits between the propshaft yoke and the pinion nut. During assembly, observe the correct pinion bearing preload according to factory specifications. One washer is required per differential or transfer case output.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : GROUP 08 - TRANSFER CASE, GROUP 10 - FRONT AXLE MB, GROUP 11 - REAR AXLE, GROUP 11 REAR AXLE DANA 44 3B
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-1803B — Ordnance Maintenance — Power Train, Body & Frame — only for Willys MB / Ford GPW (¼-ton 4×4)
