NUT HEAD CYLINDER 7/16
✅ Cylinder Head Bolt Torque – Willys MB Engine (Go Devil 134 cu in):
-
60 to 65 ft-lb
-
Equivalent to approximately 81 to 88 Nm
🔧 Important Tips When Tightening:
-
Always use a torque wrench for accuracy.
-
Follow the correct tightening sequence – typically a spiral pattern from the center outwards to prevent warping the head.
-
Tighten in stages:
-
First pass: ~35 ft-lb
-
Second pass: ~50 ft-lb
-
Final pass: 60–65 ft-lb
-
-
Engine must be cold when torquing the head bolts.
-
After the first heat cycle, recheck the torque and retighten if necessary.
TORQUE WRENCH READINGS
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : BOLTS 01 ENGINE, UPPERENGINEHEAD CJ3A, Upper Engine M38, UPPERENGINEHEAD M38, Engine complete
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Ford GPW (early) | 1942 |
| Ford GPW | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 (early) | 1956, 1957, 1958, 1959 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |
| Willys M38 | 1950, 1951, 1952 |
| Willys M38A1 | 1952, 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971 |
| CJ series | |
| Jeep CJ-2A | 1945, 1946, 1947, 1948, 1949 |
| Jeep CJ-3A | 1949, 1950, 1951, 1952, 1953 |
| Jeep CJ-3B | 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968 |
| Jeep CJ-5 | 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983 |
📐 Diagrams & technical drawings
From the original Technical Manual CJ2A_PL_1949 — Parts List — only for Willys CJ-2A / CJ-3A (1949)
