45.jpg)
45_200x200.jpg)
SPACER ROLLER BEARING INTERM GEAR M201
WO809295
Spacer roller bearing intermediate gear
For transfer case with 1-1/4" shaft
Precision spacer for the needle bearings of the intermediate gear in the transfer case. This component ensures correct separation between the needle bearing sets on the intermediate shaft, essential for smooth four-wheel drive operation.
|
Material Steel |
Type For 1-1/4" intermediate shaft |
|
Application Transfer case |
Quantity required 3 pieces per vehicle |
Features
- Precision spacer for intermediate gear needle bearings
- Suitable for transfer case with 1-1/4" (31.75 mm) intermediate shaft
- Prevents contact between needle bearing sets
- Essential for correct adjustment and bearing durability
- Important during transfer case overhaul
★ Replacement part for transfer case overhaul. Note: 3 spacers are required per vehicle for correct intermediate gear assembly.
Installation notes
When assembling the intermediate gear, 3 spacers are required per vehicle: one at each end of the needle bearing stack and one in the middle between the two needle bearing sets. Assemble with assembly grease to hold the needle bearings in place during installation.
Compatibility
Specific to transfer cases with the later 1-1/4" (31.75 mm) thick intermediate shaft. Not compatible with earlier versions with thinner 1-1/8" or 3/4" shafts. Check your transfer case shaft diameter before ordering.
Historical context
The reinforced 1-1/4" intermediate shaft was introduced from 1953-1955 in the Dana 18 transfer case. This improvement increased the bearing surface and utilised loose needle bearings instead of the earlier caged needle bearings, which improved durability.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |