CLAMP STEARING COLUMN
Screw for brake line clip dashboard
10 x 3/4 inch, round head
Original specification screw for mounting the brake line clip to the dashboard. This steel screw with round head is used to secure the tube clip that holds the front brake line in place at the dashboard.
|
Thread size 10 (.190)-24NC-2 |
Length 3/4 inch (19 mm) |
|
Application Brake line dashboard mounting |
Vehicle Willys MB, Ford GPW, CJ-3A, M38, CJ-3B |
Features
- Original Willys part number: WO-5064
- Round head screw, steel
- Thread: No. 10 (.190)-24NC-2 x 3/4 inch
- Used with brake line clip WO-A-5449
- Packaged per 2 pieces (as originally used)
★ Original specification mounting screw according to SNL G-503 Parts List. Essential small component for correct installation of the brake line system.
Application
Used for mounting the open S-shaped brake line clip (WO-A-5449) which holds the 3/16 inch brake line from the master cylinder to the front in place. This screw secures the clip to the dashboard or to the side rail reinforcement. Applied on Willys MB (from serial number 106763), Ford GPW, and later models such as CJ-3A, M38 and CJ-3B.
Installation notes
2 pieces used per vehicle (according to SNL G-503 Item 1209C). Used in combination with lock washer WO-52221. Tightening torque: tighten by hand, do not overtighten to avoid damage to clip or thread. Consult TM 9-1803B figure 12-5 for exact position of brake line clips.
Compatibility
Suitable for Willys MB from serial number 106763 (late production) and Ford GPW. Also used on CJ-3A, M38 and CJ-3B. Early Willys MB (before serial number 106763) used a different clip configuration with different mounting method. Check serial number and clip type before ordering.
Historical context
During WWII, brake lines on military jeeps were held in place along chassis and dashboard with various metal clips. This small screw was part of the critical hydraulic brake system that was applied from 1942 on all Willys MB and Ford GPW vehicles.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 (early) | 1956, 1957, 1958, 1959 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 10-1513 — Maintenance Manual — only for Willys MB / Ford GPW (1942)
