Panel Rear Wheelhouse Inside RHD MB
Inner panel rear wheelarch RHD
Reproduction steel repair panel for right hand drive
Reproduction inner panel for the rear wheelarch, specific to Right Hand Drive (RHD) configuration. This stamped steel panel restores the inside of the rear wheelarch and is essential when restoring corrosion or damage in this critical area.
|
Material Geperst staal |
Configuration Right Hand Drive (RHD) |
|
Type Binnenpaneel achterwielkast |
Application Reparatie binnenzijde wielkast achter |
Features
- Reproduction steel panel with correct pressings
- Specific to RHD configuration (mirror image of LHD)
- Stamped to original specifications
- Suitable for replacement when corroded or damaged
- Welding work required for fitting
★ Reproduction body panel manufactured in pressed steel with correct pressings and dimensions for restoration of Right Hand Drive vehicles.
Application
For Right Hand Drive vehicles only. RHD vehicles were produced for Australia, the United Kingdom, New Zealand and parts of Asia, amongst others. Please note: this panel is NOT compatible with standard LHD (Left Hand Drive) vehicles — the configuration is fully mirrored.
Installation notes
Fitting requires welding work. Test-fit the panel before final welding. Remove damaged or corroded material and weld the new panel using short tack welds (approximately every 5 cm) to prevent heat distortion. Check alignment with outer panel and wheelarch before welding completely.
Compatibility
ONLY for Right Hand Drive (RHD) configuration. Not interchangeable with Left Hand Drive (LHD) panels. RHD vehicles have a mirrored body layout with steering gear, fuel tank and tool mounting on the opposite side.
Historical context
Right Hand Drive Willys MBs were produced during and after WWII for markets with left-hand traffic, including Australia where LHD vehicles could no longer be registered from 1948 onwards. RHD bodies are fully mirrored versions with factory pressings in all panels.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 (early) | 1956, 1957, 1958, 1959 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |