GPW PEDAL SHAFT REFURBISHMENT KIT
In this kit you will get:
x1 7/16 UNC nut (118616)
x2 7/16 UNC split washers (115314)
x1 Control Tube to Stud, Frame Bracket (GPW-7509)
x2 7/16 UNC Ball End Studs (GPW-7514)
x2 Rubber Dust Seals (GPW-7512)
x2 Felt Pads (GPW-7539)
x2 F Marked Pressure Discs (GPW-7517)
x2 3/32" x 1/2" Cotter pins (103372)
x1 9/16" x 1 3/4" Compression spring (GPW-7545)
Pedal Shaft Renovation Kit
Draft seals for brake and clutch shafts
Renovation kit for pedal shaft draft sealing. This set contains the rubber discs, springs and rings that mount on the brake and clutch shafts beneath the floorplate to prevent draughts, dust and moisture. An essential component for a correctly restored cab.
|
Material Rubber, steel |
Kit contents 2 rubber discs, 2 springs, 2 rings |
|
Mounting location Pedal shafts beneath floorplate |
Function Sealing against draughts and dirt |
Features
- Complete kit for both pedal shafts
- High-quality rubber material
- Mounting hardware included
- Prevents draughts and dirt ingress
- Proven design
★ Quality reproduction to original specifications for correct restoration of your WWII jeep.
Installation notes
The rubber discs slide onto the pedal shafts and are secured with spring and ring on the underside of the floorplate. Installation is from below, from the underside of the chassis. Ensure pedal shafts are clean and undamaged before fitting.
Compatibility
Suitable for vehicles with standard pedal shaft configuration. Early WWII models (until late 1942) often had rubber discs; later models sometimes felt due to rubber shortages during the war. Check your original specification.
Historical context
During WWII, these draft seal kits were fitted as standard to keep dust, mud and cold air out of the driver's cab – essential for comfort and functionality under demanding operational conditions.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Ford GPW (early) | 1942 |
| Ford GPW | 1942, 1943, 1944, 1945 |