BRACKET BEARING BRAKE PEDAL SHAFT TO FRAME
Bracket bearing brake pedal shaft to frame
A493 - For welding to chassis frame
Reproduction of the original bracket for the bearing of the brake and clutch pedal shaft. This bracket is welded to the chassis frame at both tabs that enclose the frame rail. Essential component for correct assembly and operation of the pedal mechanism.
|
Material Steel |
Finish With brass bushings and grease nipple |
|
Mounting Welded to chassis frame |
Part number A493 / WOA493 |
Features
- Includes fitted brass bushings for smooth operation
- Provided with grease nipple (zerk fitting) for maintenance
- Welded to both tabs on the frame
- Suitable for use with pedal shaft A492 (early type)
- Direct replacement for worn or damaged original
★ Reproduction to original specifications for correct fitting and durability. Eliminates play in the brake and clutch pedal mechanism.
Installation notes
Bracket is welded to the chassis at both mounting tabs that enclose the frame rail. Ensure correct positioning: 2 inches (approx. 5 cm) from front of gearbox cross member bracket to centre of bracket tube. Bracket positions against the underside of the frame. After welding: lubricate via grease nipple for optimal operation of the brass bushings.
Compatibility
Early type (A493) is specific for use with pedal shaft A492 - this is the early shaft with split pin hole on the clutch side. Not compatible with later pedal shafts (A495, A497) which require a different bracket. Check which pedal shaft type your vehicle has before ordering.
Historical context
This component was originally welded to the chassis during production. Through years of stress and possible rust formation, the brass bushings can wear or the bracket itself may be damaged, causing play in the pedals.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB | 1942, 1943, 1944, 1945 |
| Ford GPW (early) | 1942 |
| Ford GPW | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 (early) | 1956, 1957, 1958, 1959 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |