SHIELD GENERATOR 6 VOLTS/FRAME
WOA642
Generator splash shield 6 volt
Willys MB version with additional mounting hole
Steel splash shield that protects both the air cleaner and the 6-volt generator from dirt and water spray in the engine compartment. This shield is mounted to the frame and was standard equipment on WWII jeeps. The Willys MB version features an additional mounting hole compared to the Ford GPW version.
|
Material Pressed steel |
Vehicle type Willys MB version |
|
Mounting To engine compartment frame |
Original number WOA642 |
Features
- Protects air cleaner and generator from dirt and water spray
- Willys MB specification with additional mounting hole
- Frame-mounted splash shield
- Original specification reproduction
- For 6-volt electrical system
★ Pressed steel splash shield to original Willys specification, with characteristic additional mounting hole as fitted to MB production.
Application
Suitable for Willys MB (1941-1945), Hotchkiss M201, Ford GPW, CJ-2A and CJ-3A with 6-volt electrical system. Note: this is the Willys MB version with additional hole — Ford GPW used a different variant without this extra mounting point.
Installation notes
Bolted to the frame in the engine compartment, between air cleaner and generator. The additional mounting hole provides greater stability than the Ford version. Check before fitting that the existing mounting points on the frame are correct — early and late frames may show variations.
Compatibility
Specific to Willys MB configuration. Ford GPW used a variant without the additional hole. Not interchangeable with 12-volt conversions where the generator is often replaced by an alternator — verify that the original 6-volt generator is still fitted.
Historical context
This splash shield formed part of the standard protection in the engine compartment of WWII jeeps, where the Auto-Lite 6-volt generator and oil bath air cleaner were protected against water spray and mud during off-road operations.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : 6V Dynamo Willys MB Ford GPW , 01 SGI BODY ENGINE COMPARTMENT
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |
| CJ series | |
| Jeep CJ-2A | 1945, 1946, 1947, 1948, 1949 |
| Jeep CJ-3A | 1949, 1950, 1951, 1952, 1953 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 10-1513 — Maintenance Manual — only for Willys MB / Ford GPW (1942)
