STUD MANIFOLD LONG 3/8
2 inch (≈51 mm)
Manifold stud long 3/8″
For mounting inlet and exhaust manifolds to engine block
Stud for mounting inlet and exhaust manifolds to the engine block of the L-134 engine. This long stud has 3/8″-16 coarse thread on the block side and 3/8″-24 fine thread on the nut side. Total length approx. 2 inches (50 mm).
|
Thread 3/8″-16 (block side) × 3/8″-24 (nut side) |
Length 2 inches (50 mm) — long version |
|
Application Manifold mounting L-134 engine |
Sale Per piece |
Features
- Coarse thread (3/8″-16) screws into engine block
- Fine thread (3/8″-24) for nut and spring washer
- Long version (approx. 2 inches / 50 mm)
- Replacement part for original studs
- Black steel
★ Sold per piece. A complete set for the L-134 engine consists of 2 long studs, 2 medium and 3 short studs (total 7 pieces).
Installation notes
Use thread sealant on the coarse thread entering the block — these studs seal coolant passages at the ends of the engine block. Tighten studs hand-tight and do not overtighten to prevent thread damage. Check torque after the first heat cycles.
Compatibility
Note: for the L-134 engine different stud lengths are required (short, medium, long). Check which length belongs in which position. This is the long version.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : STUDS & PLUGS, EXHAUST COLLECTOR - CJ2A, STUDS & PLUGS CJ2A, EXHAUST COLLECTOR - CJ3A, STUDS & PLUGS CJ3A, EXHAUST COLLECTOR - M38, Engine complete
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB | 1942, 1943, 1944, 1945 |
| CJ series | |
| Jeep CJ-2A | 1945, 1946, 1947, 1948, 1949 |
| Jeep CJ-3A | 1949, 1950, 1951, 1952, 1953 |
📐 Diagrams & technical drawings
From the original Technical Manual CJ2A_PL_1949 — Parts List — only for Willys CJ-2A / CJ-3A (1949)
From the original Technical Manual TM 10-1513 — Maintenance Manual — only for Willys MB / Ford GPW (1942)
