BRUSH GENERATOR 6 V (SET OF 2) JEEP
Carbon brush dynamo 6V
Set of 2 pieces
Replacement carbon brushes for 6 volt dynamos. These carbon brushes provide the electrical contact between the rotating commutator and the stationary wiring. Supplied as a set of two pieces with fixing wires.
|
Material Carbon |
Voltage 6 Volt |
|
Application 6V dynamos |
Set contents 2 pieces |
Features
- Set of 2 carbon brushes
- Complete with fixing wires
- Suitable for 6V dynamos
- Replacement part for worn brushes
- Essential for correct dynamo operation
★ Carbon brushes are wear parts that should be checked during regular maintenance. Replace them when the carbon is shorter than 10mm, or if they seat poorly on the commutator.
Installation notes
When replacing, also check the condition of the commutator. Turn the spring tension aside, remove old brushes, fit new brushes in the same direction as the originals. Ensure the spring pressure is correct and the brushes make good contact with the commutator.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Dodge | |
| Dodge WC52 weapons carrier (winch) | 1942, 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 10-1513 — Maintenance Manual — only for Willys MB / Ford GPW (1942)
