BUSHING INTERMEDIATE PLATE STARTER 6V JEEP
Starter motor intermediate bushing 6V
Intermediate bushing for armature (intermediate bushing)
Bronze intermediate bushing for the starter motor armature of 6V Autolite starter motors type MZ-4113 and MZ-4199. This bushing supports the armature at the centre location within the starter motor and is an essential wear part when overhauling original 6V starter motors.
|
Material Bronze (sintered bronze) |
Application 6V starter motor overhaul |
|
Position Intermediate armature bushing (center bearing) |
Compatible Autolite MZ-4113 / MZ-4199 |
Features
- Intermediate bushing for starter motor armature (intermediate bearing position)
- For 6V Autolite starter motors type MZ-4113 and MZ-4199
- Material: sintered bronze (self-lubricating properties)
- Indispensable when overhauling original 6V starter motors
- Precise bore and outside diameter for correct fit
★ High-quality reproduction with correct dimensions for original Autolite 6V starter motors. A must-have when carrying out a complete overhaul of your starter motor.
Application
Suitable for overhauling 6V Autolite starter motors type MZ-4113 and MZ-4199, as fitted to Willys MB (1941-1945), Ford GPW (1941-1945) and Willys CJ-2A (1945-1949) with 4-134 L-head engine.
Installation notes
The bushing carries only the radial load of the armature and is typically the smallest bearing in the starter motor. During installation: use a suitable drift to prevent misalignment. Sintered bronze bushings benefit from a brief oil pre-treatment for optimal lubrication.
Compatibility
Specific to 6V Autolite starter motors MZ-4113 and MZ-4199. Not compatible with 12V or later starter motor models. Always check the type number on your starter motor for the correct overhaul parts.
Historical context
The Autolite MZ-4113 and MZ-4199 starter motors were standard on WWII Willys MB and Ford GPW jeeps during 1941-1945, as well as on early CJ-2A models until 1949.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Ford GPW (early) | 1942 |
| Ford GPW | 1942, 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 10-1513 — Maintenance Manual — only for Willys MB / Ford GPW (1942)
