BOND STRAP SET 5
WOA5030 : Transfer case to body floor stud bond strap
WOA5031 : Rear engine support to frame cross member stud bond strap
Ground Bond Strap Set 5 pieces
Ground bond straps for CJ-2A
Set of five braided copper ground bond straps for proper electrical earthing. These straps ensure a reliable connection between various body and engine components where paint, rubber or insulating materials prevent direct metal-to-metal earthing.
|
Material Braided copper with soldered or crimped terminal eyelets |
Set contents 5 bond straps, various lengths |
|
Function Electrical earthing body and engine |
Application CJ-2A and related civilian jeeps |
Features
- Set of 5 braided copper ground straps
- Soldered or crimped terminal eyelets with mounting holes
- Essential for properly functioning 6V electrical system
- Connects insulated components to chassis/frame
- Suitable for restoration projects
★ These bond straps are essential for a reliable 6-volt system. They connect engine components, generator, body and chassis at locations where rubber engine mounts or paint interrupt the earthing.
Application
Suitable for CJ-2A and related civilian jeep models with 6-volt system. The bond straps are installed between, among others: battery box to frame, engine mount to frame, generator to starter motor, bonnet to firewall, and other crucial earthing points where insulation prevents metal-to-metal connection.
Installation notes
Fit the bond straps with star washers to ensure good electrical connection through paint. Ensure all contact points are free from corrosion. Tighten mounting bolts firmly for optimal conductivity. If in doubt about correct locations: consult the original technical manual for your specific vehicle variant.
Compatibility
Please note: WWII military jeeps (MB/GPW) had extensive bond strap sets for Radio Interference Suppression. CJ-2A civilian models have a simpler earthing system. This set is specifically for civilian applications. Early CJ-2A models may have different configurations than late models. Check your vehicle beforehand for the number and length of straps required.
Historical context
Bond straps were introduced during WWII on military jeeps to suppress radio interference by keeping all metal panels at the same electrical potential. Civilian CJ models used a more limited set of straps, primarily for reliable earthing of the 6-volt electrical system.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Ford GPW (early) | 1942 |
| Ford GPW | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 (early) | 1956, 1957, 1958, 1959 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |