A-2000B KIT WIRING JEEP STANDARD PUSH PULL HEADLIGHT SWITCH
Standard wiring loom with push-pull headlight switch
Complete for 6V electrics
Complete wiring loom for WWII jeeps equipped with push-pull headlight switch, blackout driving light on wing, trailer socket in rear panel and radio filterbox on firewall. This kit contains all necessary textile-covered cables with pre-installed connections for the entire vehicle, from front to rear.
|
Material Textielomhulde bedrading met coating |
Voltage 6 volt |
|
Switch type Push-pull koplampschakelaar met vergrendeling |
Kit contents Complete bedrading dashboard, motor, remlichten, blackout, trailer |
Features
- Pre-installed connections according to original specifications
- Textile covering with protective coating as original
- For vehicles with blackout driving light on wing
- Provided for trailer socket in rear panel
- Compatible with radio filterbox (filterette) on firewall
- Locking push-pull headlight switch
- Complete from headlamp to rear light
★ High-quality reproduction wiring loom, fully according to factory specifications with textile-covered and coated wiring as the original execution. All connections are correctly pre-installed.
⚠ Important
- Always disconnect the battery first before working on the electrical system
- Check that all connections are correct before reconnecting the battery
- Only use 6V components - do not connect 12V parts
Application
This wiring loom is specific for WWII jeeps equipped with: push-pull type headlight switch (not rotary), blackout driving light mounted on wing, trailer socket in the rear panel, and radio filterbox (filterette) mounted on the firewall below the dashboard.
Installation notes
Requires 4 x 2-wire and 2 x 3-wire connectors (not included). Disconnect the battery first before starting installation. The wiring runs from the headlamp via dashboard and engine to the rear panel. Note the correct routing via the filterette if present. Connect the push-pull switch according to original diagrams.
Compatibility
Not suitable for vehicles with rotary headlight switch (use A-2000C instead). Not suitable for early vehicles without blackout driving light, trailer socket or filterette (use A-2000A instead). Check that your vehicle is equipped with the push-pull headlight switch and the mentioned components.
Historical context
The push-pull headlight switch with locking button was used during WWII to prevent accidental activation of the normal lighting. The filterette (radio suppression filter) was installed on vehicles equipped for radio communication.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB | 1942, 1943, 1944, 1945 |
| Ford GPW (early) | 1942 |
| Ford GPW | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |