GASKETS TRANSFER CASE (SET)
Transfer Case Gasket Set
For Dana 18 transfer case
Complete set of gaskets and seals for the Dana 18 transfer case. This set contains all necessary paper gaskets, shift rail seals and output shaft seals to fully seal your transfer case. Ideal for maintenance or restoration.
|
Material Paper gaskets and rubber seals |
Transfer case Dana 18 (also called Spicer 18 or Brown-Lipe) |
|
Application CJ-2A, CJ-3A, CJ-3B, M38, M38A1 |
Kit contents Shift rail seals, output seals, all paper gaskets |
Features
- Complete set for full transfer case sealing
- Includes shift rail oil seals
- Includes front and rear output seals
- All paper gaskets included
- Suitable for maintenance and restoration
★ High-quality reproduction set according to original specifications. Contains all necessary gaskets and seals for a professional overhaul of your Dana 18 transfer case.
Application
Fits all vehicles with Dana 18 transfer case listed in the categories: CJ-2A (1946-1949), CJ-3A (1949-1953), CJ-3B (1953-1964), M38 (1950-1952) and M38A1 (1952-1966). Note: this is specific for Dana 18 - not suitable for Dana 20 or other transfer case models.
Installation notes
Use a good gasket sealant (such as Permatex gasket sealant) when fitting the paper gaskets. Always replace all seals simultaneously to prevent leaks. Check the breather on the passenger side top of the transfer case - this must be clear. Fill with SAE 90 gearbox oil after assembly.
Compatibility
Exclusively for Dana 18 transfer case. NOT suitable for Dana 20, Dana 300 or other transfer cases. The Dana 18 was used from 1941 until the early 1970s on various Willys and Jeep models. Check your transfer case type before ordering.
Historical context
The Dana 18 (also called Spicer 18 or Brown-Lipe) was the standard transfer case for military and civilian Willys Jeeps from 1941 until the early 1970s. This robust two-speed transfer case with two shift levers was an essential component of the four-wheel drive system of the legendary Jeep.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |