FRAME WILLYS CJ3A ORIG
WITH BELGIUM PAPERS
Original used chassis Willys CJ-3A
Wheelbase 80 inches (203 cm), 1949-1953
Original used chassis from a Willys CJ-3A. The CJ-3A chassis has an 80-inch wheelbase and was produced between 1949 and 1953. Please note: this is a used part with signs of wear appropriate to its age.
|
Vehicle Willys CJ-3A (1949-1953) |
Wheelbase 80 inches (203 cm) |
|
Condition Original used |
Origin Original Willys-Overland |
Features
- Original Willys CJ-3A chassis from production period 1949-1953
- Wheelbase 80 inches (203 cm), track width 48¼ inches
- Left engine support bracket faces forward (characteristic of CJ-3A)
- Suitable for restoration project or as basis for rebuild
- Used part — condition as pictured
★ Authentic Willys-Overland chassis from the early post-war Universal CJ series. The CJ-3A chassis features several important differences compared to the earlier CJ-2A model, including the forward-facing left engine support bracket required for the larger fuel/vacuum pump.
Application
Willys CJ-3A (1949-1953). Due to similar construction, partially compatible with CJ-2A and M38, but note frame differences: CJ-3A has left engine mount facing forward, CJ-2A facing rearward. M38 has boxed front section and military mounting points not found on civilian frames.
Installation notes
Before fitting, check serial number stamping on driver's side at front of frame. Verify engine mounting points: left mount must face forward (typical CJ-3A). When replacing chassis, all body mounts, suspension attachments and drivetrain components must be checked for correct fit and alignment.
Compatibility
CJ-2A and CJ-3A chassis are largely interchangeable but NOT identical. Important difference: position of left engine support bracket (CJ-2A rearward, CJ-3A forward). M38 military frames have boxed front section, tie-down points at corners and other military features — these are NOT directly interchangeable with civilian CJ frames. CJ-3B and M38A1 have longer front section for Hurricane engine.
Historical context
The CJ-3A chassis was introduced in 1949 as successor to the CJ-2A, with improvements including modified engine mounts for the new fuel/vacuum pump and reinforced leaf spring suspension (10 leaves) for agricultural applications. Produced by Willys-Overland until 1953.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : GROUP 15 - FRAME, GROUP 15 - FRAME CJ2A, GROUP 15 - FRAME CJ3A, GROUP 15 - FRAME CJ3B
📐 Diagrams & technical drawings
From the original Technical Manual CJ2A_PL_1949 — Parts List — only for Willys CJ-2A / CJ-3A (1949)
