CLIP SET WIRING WILLYS MB
Wiring Clip Set Willys MB
Complete set of mounting clips for wiring harness
Complete set of mounting clips for fitting the wiring harness to the Willys MB. The clips are used to secure the wiring at various points to the bodywork, both underneath the floor and to the rear panel and wings. Manufactured to original specification.
|
Material Steel |
Type P-clips and bendable mounting tabs |
|
Vehicle Willys MB |
Application Mounting wiring harness to bodywork |
Features
- Complete set for entire wiring harness
- P-clips with screw mounting
- Bendable tabs for floor mounting
- Double and single clips for different locations
- Manufactured to original design
★ Produced as a duplicate of the original mounting clips used on WWII Willys MB jeeps. Essential for correct and authentic installation of the wiring harness.
Application
Willys MB (1941-1945). The clips are mounted on the underside of the floor (bendable tabs), the rear panel near the rear lights and trailer connection, and at various points along the harness to the headlamps and instrument panel.
Installation notes
DO NOT fully tighten the clips before determining the final route of the wiring harness. The wiring runs through the hole in the cowl support. Use both the screwed P-clips and the welded bendable tabs underneath the floor. During restoration: check that all mounting points are present before painting the bodywork.
Compatibility
Specific to Willys MB. Ford GPW used similar clips, but some GPW clips have an 'F' marking. The set contains different types of clips for different locations: double clips with screw hole for the rear panel, single clips for other locations, and bendable tabs for floor mounting.
Historical context
The Willys MB wiring harness was fitted to the bodywork during production before it was placed on the chassis, using a combination of welded tabs and screwed clips for mounting.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB (early) | 1941, 1942 |
| Willys MB | 1942, 1943, 1944, 1945 |
| Hotchkiss M201 | 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966 |