LEVER CARBURETOR HAND THROTTLE CONTROL DODGE
Carburettor hand throttle control lever
For Carter carburettor
Lever for the hand throttle control of the carburettor. This component connects the hand throttle lever on the dashboard to the throttle valve of the carburettor, allowing manual adjustment of engine speed without using the accelerator pedal. Essential component for operating radio equipment, deep wading or prolonged idling.
|
Application Carburettor hand throttle control |
Carburettor type Carter |
|
Design Lever for throttle valve shaft |
Material Steel |
Features
- Mounting on carburettor throttle valve shaft
- Connection for hand throttle cable
- Original specification
- Robust steel construction
- Essential for correct hand throttle control
★ Manufactured to original military specification. Hand throttle control was standard on military vehicles for adjusting engine speed during radio operation, deep wading or use of auxiliary equipment.
Application
For vehicles with Carter carburettor fitted with hand throttle control. The hand throttle lever is located on the dashboard and connects via a cable to this lever on the carburettor.
Installation notes
Mounts on the throttle valve shaft of the carburettor. Ensure correct positioning so the cable connects at the proper angle. Check after installation that the throttle valve can fully close and open without binding.
Compatibility
Specific to Carter carburettors. Check before installation that your carburettor is fitted with the correct mounting points for hand throttle control. Not all carburettors had this provision.
Historical context
Hand throttle control was standard military equipment for adjusting engine speed during use of radio equipment or during deep wading when the driver had to stand upright. Also used during prolonged idling for auxiliary equipment.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Dodge | |
| Alle Dodge WC / M-serie | 1942, 1943, 1944, 1945, 1946, 1947, 1948, 1949, 1950, 1951, 1952, 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-808 — Technical Manual — only for Dodge ¾-ton 4×4 (WC series)
