MOTOR WIPER BALDE+ARM 12V REPLACEMENT
HO83248
Windscreen Wiper Motor 12V Conversion Kit
Complete with wiper blade and arm
Electric windscreen wiper motor conversion kit for 12V electrical systems. Offers a reliable upgrade to replace the original vacuum-operated wipers. Complete with motor, wiper arm, wiper blade and wiring for straightforward installation without additional drilling.
|
Voltage 12 Volt |
Type Electric conversion |
|
Mounting Top mounted |
Kit contents Motor, arm, blade, wiring |
Features
- 12V electric motor replaces original vacuum drive
- Complete with stainless steel wiper arm and wiper blade
- Includes wiring and mounting hardware
- No additional drilling required (no-drill installation)
- Sweep angle approximately 90 degrees
- Suitable for top mounted wipers on windscreen
- Switch on rear of motor
★ Practical conversion solution for more reliable operation in rainy conditions. Complete kit for one side of the vehicle — order two kits for full windscreen.
Application
This conversion kit is suitable for vehicles with top mounted windscreen wipers that have been converted to or are originally equipped with a 12V electrical system. Used to replace original vacuum-operated Trico wiper motors. Generally, two kits are required per vehicle (one per side).
Installation notes
Installation without additional drilling in the existing mounting points. Switch is located on the rear of the motor for direct on/off operation. For vehicles still fitted with vacuum lines: seal these at the fuel pump with a plug. The wiper motor mounts to the upper windscreen frame. Note: some motors have an extended shaft that may need shortening depending on specific applications.
Compatibility
Only suitable for vehicles with top mounted windscreen wipers. Does not fit vehicles with bottom mounted wipers. For vehicles with original 6V system that has not been converted, this motor is not compatible — use a 6V variant or a voltage reducer instead.
Historical context
Original WWII jeeps were fitted with vacuum-operated Trico windscreen wipers that drew their power from the engine vacuum. These systems were reliable but operated slowly at high revs. Electric conversions became popular in restorations and daily drivers from the 1970s onwards for consistent operation under all conditions.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys M38 | 1950, 1951, 1952 |
| Willys M38A1 | 1952, 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971 |
| CJ series | |
| Jeep CJ-2A | 1945, 1946, 1947, 1948, 1949 |
| Jeep CJ-3A | 1949, 1950, 1951, 1952, 1953 |
| Jeep CJ-3B | 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968 |