Rear Seat Pivot Bracket GPW
WOA2833JMP
Rear seat pivot bracket
Set of 2 pieces required per vehicle
Reproduction pivot bracket for mounting the rear seat frame to the floor pan. The round bar at the bottom of the rear seat frame rests in this bracket, allowing the seat to tilt. Supplied in sets of 2 pieces in untreated steel.
|
Material Cold-rolled steel, electrogalvanised |
Finish Untreated (requires primer and paint) |
|
Mounting Floor pan, beneath rear seat |
Set contents 2 pieces required per vehicle |
Features
- Reproduction to original specifications
- Suitable for left and right side
- Bracket features rounded cup for pivot point
- Requires mounting with suitable fastening bolts
- Supplied in raw steel (not painted)
★ These brackets are essential components for correct rear seat mounting. Often corroded on original vehicles.
Installation notes
Bolted to the floor pan beneath the rear seat, on both sides of the vehicle. The round bar of the rear seat frame (pivot post) rests in the rounded cup of the bracket. For correct installation: apply primer first, then paint in Olive Drab. Check mounting holes in floor pan for corrosion before installation.
Compatibility
Fits vehicles with rear seat using the classic pivot system with round bars. Not suitable for early vehicles with different rear seat configuration or later models with modified mounting system.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Ford GPW | 1942, 1943, 1944, 1945 |