STUDS+NUTS HEAD ENGINE JEEP (SET OF 15)
WOA1534KIT
Cylinder head studs + nuts L-134 engine
Set of 15 studs and 15 nuts
Complete set of cylinder head studs and nuts for the 134 ci L-head Go Devil engine. This set contains 15 studs and 15 nuts, sufficient for one complete cylinder head. The studs have 7/16" coarse thread (block side) and fine thread (nut side).
|
Thread 7/16"-14 x 7/16"-20 |
Stud length 5 inches (89 mm) |
|
Engine L-134 Go Devil |
Set contents 15 studs + 15 nuts |
Features
- Set of 15 studs and 15 nuts
- Coarse thread fits into engine block
- Fine thread for nuts on top side
- Length 3.5 inches per stud
- Sufficient for complete cylinder head
★ Essential component for any engine overhaul or cylinder head gasket replacement. The studs feature dual threads: coarse thread for fixing into the block, fine thread for the nuts.
Installation notes
Screw coarse thread into engine block, apply high-temperature threadlocker to coarse thread side if necessary. Cylinder head torque: 60-70 ft/lbs (81-95 Nm) following standard torque procedure. After initial running period, re-torque cylinder head to maintain proper sealing.
Compatibility
NOTE: these are studs for L-134 flathead engine with 15 studs. Do not confuse with F-134 engine (uses 15 bolts, different length). Check whether your engine is L-head (flathead) or F-head configuration.
Historical context
The L-134 Go Devil engine was the standard engine in WWII Jeeps and early civilian models until the early 1950s, when the F-134 Hurricane was introduced.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : BOLTS 01 ENGINE, UPPERENGINEHEAD CJ3A, Upper Engine M38, UPPERENGINEHEAD M38
This part fits:
| Model | Years |
|---|---|
| Military jeeps | |
| Willys MB | 1942, 1943, 1944, 1945 |
| Willys M38A1 | 1952, 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971 |
| CJ series | |
| Jeep CJ-2A | 1945, 1946, 1947, 1948, 1949 |
| Jeep CJ-3A | 1949, 1950, 1951, 1952, 1953 |
📐 Diagrams & technical drawings
From the original Technical Manual CJ2A_PL_1949 — Parts List — only for Willys CJ-2A / CJ-3A (1949)
