STARTER 12 VOLTS ASSEMBLY
Starter 12 volt complete
For 6V to 12V conversion
Complete 12 volt starter for converting the original 6 volt electrical system to 12 volt. This starter forms part of a 12V upgrade and replaces the original 6V starter.
|
Voltage 12 volt |
Type Complete assembled |
|
Application Conversion 6V → 12V |
Engine Dodge 230 ci flathead |
Features
- Complete 12V starter for conversion purposes
- Replaces original 6V starter during 12V upgrade
- Suitable for Dodge 230 ci engine with 146-tooth flywheel
- Complete assembled and ready for installation
- Requires full 12V conversion (battery, dynamo/alternator, coil, bulbs)
★ When converting to 12V, other components must also be adapted: 12V dynamo or alternator, 12V coil, 12V bulbs, and possibly resistor for fuel gauge.
Application
For conversion from 6 volt to 12 volt electrical system on Dodge WC-series vehicles with 230 cubic inch flathead engine and 146-tooth flywheel ring gear. Many Dodge WC ½-ton and ¾-ton vehicles were originally supplied with 6V; some late WC51/WC52 (late 1944/1945) had factory 12V for radio use.
Installation notes
Please note: this starter only works in combination with a complete 12V system. Required: 12V battery, 12V dynamo or alternator with voltage regulator, 12V coil, all bulbs replaced with 12V version. Fuel gauge usually requires a resistor (±22 ohm) to prevent burning out. Earthing is usually converted from positive ground (6V) to negative ground (12V) during conversion.
Compatibility
Fits Dodge WC-series with 230 ci engine and 146-tooth flywheel. NOT compatible with 6V systems — use only with complete 12V conversion. Check number of teeth on flywheel ring gear before ordering (146 teeth for WC ½-ton and ¾-ton).
Historical context
Many post-war armies (including Norway, Switzerland) converted their 6V Dodge WC vehicles to 12V for improved starting performance and compatibility with radio equipment. Nowadays a popular upgrade for daily use.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
⚠ Spotted an error in this description? Report it to info@willys.be
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Dodge | |
| Dodge WC52 weapons carrier (winch) | 1942, 1943, 1944, 1945 |
| Dodge WC53 carryall | 1942, 1943, 1944 |
| Dodge WC54 ambulance | 1942, 1943, 1944 |
| Dodge WC55 gun motor carriage | 1942, 1943 |
| Dodge WC56 command car | 1942, 1943, 1944, 1945 |
| Dodge WC57 command car (winch) | 1942, 1943, 1944, 1945 |
| Dodge WC58 radio command car | 1942, 1943, 1944, 1945 |
| Dodge WC63 6x6 (winch) | 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-808 — Technical Manual — only for Dodge ¾-ton 4×4 (WC series)
