PAD DRAFT TRANSMISSION LEVERS DODGE WINCH
Draught Excluder Transmission Levers
For Dodge WC with winch (with PTO lever opening)
Reproduction of the original draught seal for transmission and transfer case levers on Dodge WC 3/4 ton vehicles. This version features an additional opening for the PTO lever (Power Take-Off) and is therefore specifically intended for vehicles equipped with a front winch.
|
Material Rubber/vilt compositie |
Type Met PTO-hendelgat |
|
Application WWII Dodge WC 3/4 ton met lier |
Function Tochtafdekking cabine-vloer |
Features
- Reproduction of original WWII part
- With opening for PTO lever (winch vehicles)
- Protects against dust, moisture and draughts
- Fitted around transmission and transfer case levers
- Specific for 3/4 ton WC series with Braden winch
★ This reproduction pad is essential for a correct restoration of Dodge WC winch vehicles. The extra hole for the PTO lever distinguishes this version from the standard version without winch.
Application
Suitable for Dodge WC 3/4 ton 4x4 vehicles (1942-1945) equipped with a front winch, such as WC-52, WC-57 and WC-63 winch models. The PTO lever operates the drive of the Braden MU-2 winch via the transmission.
Installation notes
Installation on the cab floor around the transmission and transfer case lever openings. The opening for the PTO lever must be positioned on the left side (driver's side) of the transmission lever. Fit before installing the levers and knobs.
Compatibility
ONLY for Dodge WC models with front winch. Vehicles without winch use the standard pad without PTO hole (CC966650). Not compatible with 1/2 ton WC models or 6x6 models — these have different configurations.
Historical context
During WWII, approximately 1 in 10 Dodge WC cargo trucks were equipped from the factory with a Braden winch. The PTO drive was located on the left side of the transmission and required a separate lever through the cab floor.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Dodge | |
| Dodge WC51 weapons carrier | 1942, 1943, 1944, 1945 |
| Dodge WC52 weapons carrier (winch) | 1942, 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-808 — Technical Manual — only for Dodge ¾-ton 4×4 (WC series)
