HINGE HOOD DODGE (2 HALFS)
Bonnet hinge Dodge WC-series
Complete with tubular rivets – set of 2 halves
Bonnet hinge for Dodge WC-series lorries, consisting of two hinge halves (male and female part) that slide into each other. The hinge connects both bonnet halves and is secured with tubular rivets.
|
Material Steel |
Finish Bare steel – ready for primer and paint |
|
Application Dodge WC-series military lorries |
Fastening With tubular rivets |
Features
- Reproduction of original part
- Consisting of 2 hinge halves that slide into each other
- Suitable for fitting with tubular rivets
- For mounting between both bonnet halves
- Complete hinge system
★ Accurate reproduction of the original Dodge WC bonnet hinge. After assembly, the two halves form a functioning hinge that connects both bonnet halves and allows smooth opening.
Application
Suitable for Dodge WC-series 3/4 ton 4x4 lorries (1942-1945) and 1-1/2 ton 6x6 models (1943-1945). Also usable for post-war Dodge Power Wagon models. For Dodge WC 1/2 ton 4x4 (1941-1942), modification may be required.
Installation notes
Both hinge halves are each secured with tubular rivets to the respective bonnet half. Recommended procedure: drill out old rivets, repair and straighten bonnet halves, prime and possibly pre-paint the internal sides that will no longer be accessible after assembly, secure hinges with tubular rivets, then slide the two hinge halves into each other. A riveting tool with the correct die for tubular rivets is recommended for proper finishing.
Compatibility
Fits most 3/4 ton and 6x6 Dodge WC models without modification. For 1/2 ton models (WC-1 through WC-50), some adaptation may be required – note that WC53/WC54 ambulance models had a slightly longer hinge version due to the angled bonnet. Replace both hinge halves simultaneously for correct operation.
Historical context
The Dodge WC bonnet hinge was a characteristic element of the WWII-era Dodge lorries. The bonnet consisted of two halves that opened from the centre, connected by a central hinge with tubular rivets – a robust construction suitable for military field conditions.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Dodge | |
| Dodge WC51 (early) | 1942 |
| Dodge WC52 weapons carrier (winch) | 1942, 1943, 1944, 1945 |
| Dodge WC56 command car | 1942, 1943, 1944, 1945 |
| Dodge WC57 command car (winch) | 1942, 1943, 1944, 1945 |
| Dodge WC58 radio command car | 1942, 1943, 1944, 1945 |
| Dodge WC63 6x6 (winch) | 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-808 — Technical Manual — only for Dodge ¾-ton 4×4 (WC series)
