ROD SHOCK ABSORBER REAR BALL TYPE
6 inch 15,24 cm
Here is the complete TM-style information for the ROD – Shock Absorber Rear (Ball Type), as used on Dodge WC-51, WC-52, WC-53, WC-54 and other ¾-ton WC series with rear ball joint mounting.
Data is based on TM 9-1808A – Suspension Group and original factory specifications.
Part name: ROD – Shock Absorber Rear (Ball Type)
Application:
-
Dodge WC-51, WC-52, WC-53, WC-54 (¾-ton 4x4)
-
Rear axle, connection between frame and rear shock absorber with ball joint
-
Specific to versions with ball stud type upper or lower mount
Function:
Links the ball joint to the shock absorber body and ensures correct guidance of the piston rod.
Technical specifications (TM average):
-
Length, center-to-center: ± 5.75" (146 mm)
-
Rod diameter: ± 0.625" (15.88 mm)
-
Thread: 7/16-20 UNF (fine thread)
-
Material: forged steel, hardened at contact points
-
Finish: black phosphate or cadmium plating
Installation sequence (TM 9-1808A):
-
Raise vehicle to relieve rear axle.
-
Remove cotter pin and nut from ball joint.
-
Disconnect from shock absorber.
-
Install new rod, tighten nut and fit cotter pin.
-
Check for play through full suspension travel.
Maintenance:
-
Inspect ball joint and threads every 1,000 miles (1,600 km).
-
Lubricate ball joint according to TM schedule.
-
Replace if play is detected or dust boot is damaged.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Dodge | |
| Dodge WC52 weapons carrier (winch) | 1942, 1943, 1944, 1945 |
| Dodge WC53 carryall | 1942, 1943, 1944 |
| Dodge WC54 ambulance | 1942, 1943, 1944 |
| Dodge WC55 gun motor carriage | 1942, 1943 |
| Dodge WC56 command car | 1942, 1943, 1944, 1945 |
| Dodge WC57 command car (winch) | 1942, 1943, 1944, 1945 |
| Dodge WC58 radio command car | 1942, 1943, 1944, 1945 |
| Dodge WC63 6x6 (winch) | 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-808 — Technical Manual — only for Dodge ¾-ton 4×4 (WC series)
