SHOCK ABSORBER REAR RIGHT WC51/52/ETC (CONE)
Part name: SHOCK ABSORBER – Rear Right (Cone Type)
Application:
-
Dodge WC-51, WC-52, WC-53, WC-54 (¾-ton 4x4)
-
Rear axle, right side
-
Upper mount: cone stud, lower mount: eye with rubber bushing
Function:
Double-acting hydraulic telescopic shock absorber that dampens vertical and lateral rear axle movement to improve comfort, stability, and load control.
The cone-shaped upper stud provides self-centering and vibration-resistant mounting.
Technical specifications (TM):
-
Type: double-acting, hydraulic, serviceable
-
Extended length: ± 21.50" (546 mm)
-
Compressed length: ± 13.00" (330 mm)
-
Stroke: ± 8.50" (216 mm)
-
Upper mount: cone stud, base Ø ± 11/16" (17.46 mm)
-
Lower mount: eye with rubber bushing, bolt Ø 7/16" (11.11 mm)
-
Cylinder diameter: ± 1.625" (41 mm)
-
Fluid: MIL-O-13826 shock absorber oil
Installation sequence (TM 9-1808A):
-
Raise vehicle to relieve rear axle load.
-
Remove nut from upper cone stud.
-
Detach lower mounting bolt.
-
Install new shock absorber, lower end first.
-
Insert upper cone stud and tighten nut.
-
Check for free suspension travel.
Maintenance:
-
Inspect for leaks and worn bushings.
-
Check stroke: smooth and even without hesitation.
-
Always replace in axle pairs.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
This part fits:
| Model | Years |
|---|---|
| Dodge | |
| Dodge WC51 weapons carrier | 1942, 1943, 1944, 1945 |
| Dodge WC52 weapons carrier (winch) | 1942, 1943, 1944, 1945 |
📐 Diagrams & technical drawings
From the original Technical Manual TM 9-808 — Technical Manual — only for Dodge ¾-ton 4×4 (WC series)
