STUD WHEEL REAR LEFT GMC BANJO (NO DEMOUN)
Wheel Stud Rear Hub Left
Banjo rear axle, non-removable type
Non-removable wheel stud for the left rear hub of GMC lorries with Banjo-type rear axle. This variant is permanently pressed into the hub and forms a fixed connection, unlike removable studs. Essential component for wheel mounting on the rear axles of the 2½-ton GMC CCKW.
|
Type Niet-demonteerbaar (vast geperst) |
Position Achternaaf links |
|
Axle type Banjo-achteras |
Part number GM3660031 |
Features
- Permanently pressed into hub type
- Specific for left rear hub
- Only suitable for Banjo-type rear axle
- Original GM specification
- Replacement part for damaged or worn studs
★ This is the non-removable variant that is permanently pressed into the wheel hub. Installation requires special pressing equipment to position the stud correctly.
Application
Intended for GMC CCKW lorries with Banjo-type rear axles (corporate axle). The GMC CCKW was produced from the early 1940s with two different rear axle systems: the early Timken split-axle and the later Banjo-axle (corporate axle) from the Chevrolet division. Check which axle system your lorry has before ordering.
Installation notes
This wheel stud must be pressed into the hub using a hydraulic press. Ensure the hub is clean and free from corrosion. Pay attention to the correct orientation (left/right) — some systems use different thread directions per side. After installation, check that the stud is level and protrudes sufficiently for correct wheel mounting.
Compatibility
Only suitable for GMC CCKW with Banjo-type rear axles. NOT interchangeable with Timken split-axle variants — these have different wheel studs. The Banjo rear axle was used on both CCKW-352 (short wheelbase) and CCKW-353 (long wheelbase) models, and shares many parts with the DUKW amphibious lorry. Check your original part number before ordering.
Historical context
The Banjo rear axle was introduced by GMC when Timken could not keep up with production demand during the Second World War. GMC therefore switched to axles from the Chevrolet division, which resulted in two different axle systems within CCKW production.
This description was generated automatically. Unsure about fitment? Contact us at info@willys.be.
This part is intended for the restoration of historic military vehicles. Fitting, aligning, deburring or reworking is part of that work and is inherent to the nature of these goods. Dimensional variation also exists between original vehicles.
Installation requires technical knowledge of the vehicle. Unsure whether this part suits your version? Ask us before purchase at info@willys.be.
ALL_CATEGORIES : AXLES REAR BANJO
This part fits:
| Model | Years |
|---|---|
| GMC | |
| GMC CCKW 352 (short wheelbase) | 1941, 1942, 1943, 1944, 1945 |
| GMC CCKW 353 (long wheelbase) | 1941, 1942, 1943, 1944, 1945 |